Verex VeDVR User's Guide download pdf (Page 275)

21-0381E v4.9.1

Welcome Report Control Admin

Sys Config Tech-Ref

267

Command 

This allows a button or sensor to command an aspect

or device for any (or all) panels in an account. This tab

appears only if the 'Point Type' (previous/above) is a

'custom type' set as a 'command point'.

Related Settings

: Configuration, Custom Point

Types.

See: Input Points—Custom Point Type (to follow).

Tip

: For additional operating details, refer to "Notes /

Attention" at the end of this section.

- Command Type: Whether the command is to

affect area(s), door(s), or system (panel-wide)

aspects.

Tip: Select a command type, and then look under

"Command" to see the available choices.

- Command: The specific action to occur when

the sensor/input is tripped.

Items separated with a slash (/): This performs a

'toggle' operation between the indicated states each

time the sensor/input is tripped.

(Force and Exit Delays)

: Exit delays means the

affected areas will get an exit delay warning rather

than arming immediately. Force (short for 'force arm')

means if a point is insecure, the area still arms, and

then the point will be reported as 'In Alarm').

Remote RTE

: Momentary unlock using the standard

duration.

Challenged RTE

: Momentary unlock using the

extended/challenged duration.

 Pertaining to Bad Card/PIN

: Refer to Bad

Card/PIN  under "Account-Wide Panel Settings".

 Pertaining to User Count

and Area Activity: Refer

to Counting  and Activity  in the 'Area'

configuration topic.

Various/Other

: See the command lists at the end of

"Maps and Video (Visual Monitoring &

Status/Control)".

- Multiple Panel Command: Whether or not the

command is to affect all panels in the specific

account (versus selecting a specific panel).

Note: For area and door commands, this would

typically be used with the "All" selection. (If you select

a specific door or area number, the command will

affect that area/door number for all

panels).

- Area / Door: For area and door commands,

select the target item here.

Without Multiple Panel Command: This lists areas or

doors for each panel (in the panel-order as shown in

the 'tree').

With Multiple Panel Command

: This lists area/door

numbers (or "All"), and will affect all panels in the

account.

- Panel: For a single-panel command, select the

panel here.

-------------------------

Blue Text at the Bottom

This shows a reminder of the your selected

command, and the selected panel (if

applicable).

Tip: If a panel is NOT shown, this means the

command will affect all panels (i.e., a 'multi-panel

command').

-------------------------

Notes / Attention:

 Multi-panel and cross-panel commands are routed

through the Director software. As such, the source

and target panels must be communicating with the

Director software when the input/button is tripped.

 Other than issuing the specific action, command-

points are monitored only for 'Tamper' conditions (re:

Transmit, Sonalert, and Siren).

 Command Points are fixed as 'Supervisory'.

Related Settings

: Configuration, Custom Point

Types.

See: Input Points—Custom Point Type (to follow).

About Video Events

Video events are specific events pertaining to

input points and doors that have been

associated with recordings from one or two

1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 382 383

Comments to this Manuals

No comments

Verex VeDVR User's Guide Page 275

Comments to this Manuals

Related products and manuals for Digital Video Recorders (DVR) Verex VeDVR